Jump to content

P90 SBR


Leadmaster

Recommended Posts

Recently SBRd an SP5 and was now looking to do the same to a PS90. However I noticed the OAL was under the 26 limit that Ive heard ATF will deny you for.

 

Is there a configuration that I can get approved?

 

Such as using these spacers:

http://damageindustriesllc.com/store/index.php?route=product/product&product_id=2540

 

And this muzzle device:

https://patriotfirearmsusa.com/product/cmmg-57da5be-fnh-p90-5.7mmx28mm-flash-hider-m12x1-lh-black-steel

 

So that I can take the spacers off after getting the stamp but still have the form1 configuration to switch back to. Not sure of the above will get me to 26 though.

 

Thanks!

Link to comment
Share on other sites

To add to that, even in stock configuration, the ps90 is a little over 26 inches stock. 26.2 I think. So you’re going to have to add the same amount that you’re taking off.

Might be able to add more spacers and just get some longer screws. Would it be legal to SBR it like that and then remove them once the stamp comes in? IIRC the 26” is an ATF CYA thing and Illinois law says only reenactors have to follow it.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...