StuckInIllinois Posted May 6, 2021 at 08:43 PM Share Posted May 6, 2021 at 08:43 PM Recently purchased a Poly80 full size 80% frame kit for a project. Not concerned with my ability to complete the project, but looking for any advice as to what parts to look for, and possibly stay away from by any experienced builders. Trying to stay on a reasonable cost level, and the Brownells stuff looks like it may fill my needs. When back in stock. Thanks for any advice. Link to comment Share on other sites More sharing options...
once0217 Posted May 7, 2021 at 12:31 AM Share Posted May 7, 2021 at 12:31 AM Most lower parts kits are Glock factory parts, so basically they're all the same. So the cheaper you can get one the better. Link to comment Share on other sites More sharing options...
rmart Posted May 7, 2021 at 10:28 AM Share Posted May 7, 2021 at 10:28 AM Check out Marine Gun Builder on youtube and here: https://www.marinegunbuilder.com/A lot of good information including tutorials on how best to build your project. Plus, he's fun to watch. Link to comment Share on other sites More sharing options...
Craigcr2 Posted May 7, 2021 at 11:35 AM Share Posted May 7, 2021 at 11:35 AM I built an SC a few months ago. I agree with the post above about using OEM lower parts. I have the Brownells slide and upper parts from Shadow Systems. My barrel is a Lone Wolf. The build is going to reflect the time you put into it. Mine has several hours of work invested. My biggest challenge was fitting the front locking block. The P80 quality control flat out sucks. I spent several hours sanding that thing to get my slide to sit level l. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.