Glock23 Posted September 24, 2017 at 08:00 PM Share Posted September 24, 2017 at 08:00 PM Anyone have a console vault and installed custom foam cutouts for your firearm? I recently bought a console vault for my Silverado, but haven't installed it yet. I've never done my own foam, so looking for ideas, what kind of foam to use, etc. The Silverado console has a divider in the front that runs side to side, so I was thinking thick foam with vertical cutouts up front for extra mags... then thick foam behind the divider to hold the handgun horizontally like a small pistol case. Sent from my SAMSUNG-SM-N920A using Tapatalk Link to comment Share on other sites More sharing options...
mikew Posted September 24, 2017 at 09:55 PM Share Posted September 24, 2017 at 09:55 PM Take a look at this thread.It changed my life. http://illinoiscarry.com/forum/index.php?showtopic=66593 Link to comment Share on other sites More sharing options...
3ddiver Posted September 25, 2017 at 08:29 PM Share Posted September 25, 2017 at 08:29 PM I stuck big rubber covered magnets to the back wall of mine and stick my gun to it when I have to stow it. There is way more surface area on the magnets sticking to the vault than there is sticking to the gun so the gun pulls right off. I did that so it was always in the same place and not just bouncing around, probably the same reason you are looking to do something. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.