Getzapped Posted April 27, 2012 at 07:51 PM Share Posted April 27, 2012 at 07:51 PM i would soak the barrel in hoppes! it would do no good to soak the snake, and unless you have feet like a teradactyl i would advise against that!!! Link to comment Share on other sites More sharing options...
vezpa Posted April 27, 2012 at 09:12 PM Share Posted April 27, 2012 at 09:12 PM People shoot glocks with sand and mud in them. There is no damage to your gun. Shoot it and be a happy owner. Link to comment Share on other sites More sharing options...
TyGuy Posted April 28, 2012 at 05:05 AM Author Share Posted April 28, 2012 at 05:05 AM I tried to clean the heck out of it. Soaked it in Hoppes 9 bushed, lather rinse repeat. I still see the marks. :-( I think it might be scratched. If not the boresnake then I don't know what it is from. I mightnbe able to shoot tomorrow or Sunday. I'll post my shooting results. Link to comment Share on other sites More sharing options...
Getzapped Posted April 28, 2012 at 02:01 PM Share Posted April 28, 2012 at 02:01 PM It'll be fine just factory marks in it! shoot it and be happy! Link to comment Share on other sites More sharing options...
TyGuy Posted July 19, 2012 at 03:48 PM Author Share Posted July 19, 2012 at 03:48 PM I got a Beretta 92 FS Inox about two months ago, and while cleaning it last night I noticed the same marks in the barrel where the cartridge enters. My guess it that it is normal now as I didn't do to the 92 what I accidentally did to the Glock. Link to comment Share on other sites More sharing options...
rebel49 Posted July 20, 2012 at 04:46 AM Share Posted July 20, 2012 at 04:46 AM Take a tight fitting Jag and patch and some JB Bore paste and try polishing the marked area. If ti's a chatter mark from manufacturing or a flaw in the rifleing the bore paste will not remove it. However if it's fouling it will come out with the bore paste.I have had several pistols in various brands show severe fouling in the bores over the last couple of years from one particular brand of ammo. And it is tough to remove, I mean real tough and none of the copper solvents I have tried has had any effect on the fouling, and I tried them all. If it is fouling be prepared to scrub real hard and long.Good LuckRebel49 Link to comment Share on other sites More sharing options...
anonymous too Posted July 20, 2012 at 12:46 PM Share Posted July 20, 2012 at 12:46 PM Why did Glock several years ago start using rifled bbl's instead of using the polygonal bbl exclusively? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.